The Jeep Wrangler is a popular vehicle for venturing off the beaten path and into the unknown. What about a trip to the beach, though?Some individuals like to drive their Jeep Wrangler to the beach with their surfboards since it can accomplish a lot of things. Surfboards are difficult to transport due to their great size, which makes most vehicles incapable or difficult to handle.
Can a Jeep Wrangler Fit a Surfboard?
Yes, you can fit a surfboard inside your Jeep Wrangler in a number of different ways. You might just buy a rack, which comes in a variety of models and styles to assist you in carrying your board.Remove the top or back of the board and let it “hang” from the vehicle’s interior. If you do this, make sure the board is securely fastened to avoid endangering your car or anybody else.Roof racks are one option, but you may also simply lower the top and secure it to the roll bars. The simplest approach is to fold the back seats down and hang it out the back window.
Surfboard Attachment
If you take the top off, this will work; if you leave it on, you’ll need to get a safari rack. I tie down my surfboard with two surfboards tie down straps that you can get at any surf store. Place the board upside down, tail pointing front, on top of the roll cage and windshield. Then, wrap one strap under the B Hoop, over the board, and back under the B Hoop, then join and tighten the strap.
Repeat the process as near to the windshield as possible, looping around one windshield spreader bar, the surfboard, and the other windshield spreader bar, then connecting and tightening the strap. I used to do this with my boards while I was going from Annapolis to Myrtle Beach and back. Unless the top is up, in which case I simply bungee it in the back seat, like you are doing now.
Surfboard Rack for Jeep Wranglers
The new jeeps aren’t as familiar to me as the older ones. But there’s always been an issue with the old: racks. If you have a soft top, this is especially true. There are racks that work with the soft top, but they’re all kind of ugly and none of them are really built for surfers; instead, they’re all designed for off-road luggage. Not to mention the fact that they reduce gas consumption. Drilling racks into a hard top has always been the best bet. Drilling into the hard top isn’t difficult; all you have to do is measure ten times and drill once.
How to place a surfboard on your car’s roof:
1. Place the EVA foam pad in front of the windshield.
2. Position the EVA foam block in the back near the trunk door or antenna.
3. Place your surfboard, fins facing up, on top of your car
4. Double-check that the board only comes into contact with the foam cushions and not with the car.
5. Add a front strap and a back strap
6. Make sure all four doors are open;
7. Place the two cam buckles on the interior of the automobile, in the middle.
8. Thread the strap through the clasp on the opposite side of the automobile, beginning at the bottom and working your way up;
9. Tighten the straps but not too much
10. To protect the straps on the top of the surfboard from humming at fast speeds, twist them.
What are the requirements for transporting a surfboard on the roof?
Is there anything I can do to make it easier to carry with or without the top on? To avoid damaging the board, I need to be able to mount some pads. Because 8’8″ will extend into the front seat and I have the Tuffy Box in the back cargo area, I don’t want to bring it inside. I refuse to disassemble it every time I go surfing. I used to utilize a portableboard rack that I ran into the cab and sealed the doors on. There are two spherical foam padding on the front and rear, as well as straps. With a full rack now. When the top was off, I used one pad on the front windshield and the other on the sound bar, and it easily held an 8’6″ Spyder and a 6’7″ rusty. It also worked with the doors open.
How do you attach a surfboard to a jeep?
Place the board against the glass of the car or van, but not all the way. If you forcefully close the trunk, the tip of your board is likely to smash the windshield. There is no such thing as a bad idea when it comes to towels. Long lengths of time should not be spent with your board locked inside the automobile.
How do you break into a Jeep Wrangler?
For the first 300 miles, keep your speed down.Speeds of 50 to 55 mph are desirable after the first 60 miles. A good break-in is aided by a brief burst of full throttle while cruising. In low gear, wide-open throttle acceleration is dangerous and should be avoided.
Do jeep Wranglers roll over easily?
Fiat Chrysler Automobiles (FCA), Jeep’s parent company, had a direct response to the Jeep Wrangler’s crash-test results. After hitting the test barrier in both of the IIHS’s tests, the Wrangler rolled onto its passenger side. The Wrangler did not flip over during the test that FCA submitted.
Best surfboard rack for Jeep Wrangler
- Black Textured Barricade Roof Rack
- Roof Rack with Two Bars (Barricade)
- 4×4 Roof Rack RedRock Full Length
- Rhino-Rack Vortex SG 2 Bar Roof Rack in Black